[contact-form-7]
A piston ring is a split ring that fits into a groove on the outer diameter of a piston in a reciprocating engine such as an internal combustion engine or steam engine. The three main functions of piston rings in reciprocating engines are :

The post Piston Rings appeared first on Spare Parts Pakistan.

[contact-form-7]
Most reciprocating internal combustion engines end up turning a shaft. This means that the linear motion of a piston must be converted into rotation. This is typically achieved by a crankshaft.

The post Crankshaft appeared first on Spare Parts Pakistan.

[contact-form-7]
A piston is a component of reciprocating engines. It is located in a cylinder and is made gas-tight by piston rings. Its purpose is to transfer force from expanding gas in the cylinder to the crankshaft via a piston rod and/or connecting rod. In two-stroke engines the piston also acts as a valve by covering and uncovering ports in the cylinder wall.

The post Piston appeared first on Spare Parts Pakistan.

The post Cyliner Sleeves appeared first on Spare Parts Pakistan.

[contact-form-7]
The enormously heavy cylinder block houses the cylinders that give an engine its power, and it must be incredibly strong to withstand the immense heat generated by the internal combustible engine. The block itself consists of a single piece of metal. Originally, all cylinder blocks were made out of cast iron, and large engines still rely on cast iron cylinder blocks. Smaller engines, however, that do not generate extreme heat levels use aluminum cylinder blocks.

The post Cylinder Block appeared first on Spare Parts Pakistan.

[contact-form-7]
Continuous combustion engines—as well as piston engines—usually have valves that open and close to admit the fuel and/or air at the startup and shutdown. Some valves feather to adjust the flow to control power or engine speed as well.

The post Control Valves appeared first on Spare Parts Pakistan.

[contact-form-7]
In piston engines, the valves are grouped into ‘inlet valves’ which admit the entrance of fuel and air and ‘outlet valves’ which allow the exhaust gases to escape. Each valve opens once per cycle and the ones that are subject to extreme accelerations are held closed by springs that are typically opened by rods running on a camshaft rotating with the engines’ crankshaft.

The post Piston Engine Valves appeared first on Spare Parts Pakistan.

[contact-form-7]
Most internal combustion engines now require a fuel pump. Diesel engines use an all-mechanical precision pump system that delivers a timed injection direct into the combustion chamber, hence requiring a high delivery pressure to overcome the pressure of the combustion chamber. Petrol fuel injection delivers into the inlet tract at atmospheric pressure (or below) and timing is not involved, these pumps are normally driven electrically. Gas turbine and rocket engines use electrical systems.

The post Fuel Pump appeared first on Spare Parts Pakistan.

[contact-form-7]
Most internal combustion engines now require a fuel pump. Diesel engines use an all-mechanical precision pump system that delivers a timed injection direct into the combustion chamber, hence requiring a high delivery pressure to overcome the pressure of the combustion chamber. Petrol fuel injection delivers into the inlet tract at atmospheric pressure (or below) and timing is not involved, these pumps are normally driven electrically. Gas turbine and rocket engines use electrical systems.

The post Fuel Injection appeared first on Spare Parts Pakistan.

[contact-form-7]
Simpler reciprocating engines continue to use a carburetor to supply fuel into the cylinder. Although carburetor technology in automobiles reached a very high degree of sophistication and precision, from the mid-1980s it lost out on cost and flexibility to fuel injection. Simple forms of carburetor remain in widespread use in small engines such as lawn mowers and more sophisticated forms are still used in small motorcycles.

The post Carburetor appeared first on Spare Parts Pakistan.